Metz MECABLITZ 50 AF-1 digital Olympus User Manual Page 87
- Page / 166
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
87
ķ
7.2 Manual flash mode
In the manual flash mode M , the flash unit emits the full uncontrolled amount of
light if no partial light output has been selected. The specific photographic situa-
tion can be taken into account by adjusting the aperture setting or by selecting a
suitable manual partial light setting. The setting area ranges from P 1/1 to
P 1/128 in M mode and P1/1 - P1/32 in M-HSS mode. The display shows the
distance at which the subject is correctly lit (see 5.2).
Setting procedure
• Press „Mode“ until „ “ flashes in the
display.
The setting takes effect immediately.
After about 5 seconds the display stops
flashing and the setting is saved automati-
cally. „ “ appears in the display.
Manual partial light output levels
In manual flash mode set the partial
light output desired with the buttons
+ and —. The setting takes effect immedia-
tely and is saved automatically. The distance
display is adjusted to the partial light output
automatically (see 5.2).
Various camera models support the manual flash mode only in the
camera mode manual M! In other camera models an error message
appears in the display and the release is locked!
M
☞
M
M
M
7.3 Automatic high-speed synchronisation (FP or HSS)
Various cameras support automatic FP high-speed synchronisation (see the
camera’s operating instructions). This flash mode makes it possible to use a flash
unit even with shutter speeds that are faster than the flash sync speed.
Interesting results may by achieved in this mode when, for example, a wide
open aperture (e.g., f/2.0) is used to limit the depth of field in portrait shots
taken in very bright ambient light. The flash unit supports high-speed synchroni-
sation in TTLand M flash modes.
For physical reasons, however, high-speed synchronisation significantly reduces
the number and the maximum flash range. Be sure to note, therefore, the flash
range on the display of the flash unit. High-speed synchronisation is activated
automatically if a shutter speed faster than the flash sync speed is set on the
camera, whether manually or automatically by the exposure program.
Note that in the case of high speed synchronisation the guide number of
the flash unit also depends on the shutter speed. The faster the shutter
speed, the lower the guide number!
Setting procedure
• repeatedly press the„Mode“ button
until„ HSS“ or „ HSS“ flashes in
the display.
The setting takes effect immediately.
After about 5 seconds the display stops flashing
and the setting is saved automatically.
„ HSS“ or „ HSS“ is shown in the
display. High-speed synchronisation can be deleted
by repeatedly pressing the „Mode“ button until the „HSS“ symbol disappears.
MTTL
MTTL
☞
6,1
m
Zoom
50
mm
M
M
☛
P 1/4
3,0
m
Zoom
50
mm
M
M
☛
P1/4
8,1
m
Zoom
35
mm
TTL
TTL
HSS
☛
HSS
709 47 0183.A3 50AF-1 Oly 17.12.2010 13:16 Uhr Seite 87
- MECABLITZ 50 AF-1 digital 1
- 1 Sicherheitshinweise 3
- 2 Dedicated-Blitzfunktionen 4
- 3 Blitzgerät vorbereiten 4
- 4 LED-Anzeigen am Blitzgerät 6
- 5 Anzeigen am Display 6
- 6 Anzeigen im Kamerasucher 7
- 7 Blitzbetriebsarten („Mode“) 8
- 7.2 Manueller Blitzbetrieb 9
- 9 Sonderfunktionen („Select“) 11
- Remote-Betriebsarten 13
- Remote-Gruppen 14
- Remote-Kanäle 14
- Reflektorposition bei Remote 15
- 9.2.2 SERVO-Betrieb 16
- 10 Blitztechniken 20
- 11 Blitzsynchronisation 21
- 12 Automatischer AF-Messblitz 22
- 14 Wartung und Pflege 22
- 15 Hilfe bei Störungen 23
- 16 Technische Daten 25
- 17 Sonderzubehör 26
- Batterie-Entsorgung 26
- Garantiebestimmungen 27
- Avant-propos 29
- 1 Consignes de sécurité 29
- 2 Fonctions flash dédiées 30
- 3 Préparation du flash 30
- 5 Indications sur l’écran 32
- 5.2 Affichage de la portée 33
- 7.2 Mode flash manuel 35
- Modes Remote 39
- Groupes Remote 40
- Canaux Remote 40
- 9.2.2 Modo flash SERVO 42
- 11 Synchronisation du flash 47
- 14 Maintenance et entretien 48
- 17 Accessoires en option 52
- Elimination des batteries 52
- Voorwoord 55
- 1 Veiligheidsinstructies 55
- 2 Dedicated flitsfuncties 56
- 3 Flitser gereedmaken 56
- 7 Flitsfuncties (‘Mode’) 60
- 7.2 Manual flitsfunctie 61
- (FP, c.q. HSS) 61
- Remote-functies 65
- Remote-groepen 66
- Remote-kanalen 66
- 9.2.2 SERVO-functie 68
- 10 Flitstechnieken 72
- 11 Flitssynchronisatie 73
- 12 Automatische AF-meetflits 74
- 14 Onderhoud en verzorging 74
- 16 Technische gegevens 77
- 17 Bijzondere toebehoren 78
- Afvoeren van de batterijen 78
- Introduction 81
- 1 Safety instructions 81
- 2 Dedicated flash functions 82
- 5 Information in Display 84
- 5.2 Range display 85
- 7 Flash modes („Mode“) 86
- 7.2 Manual flash mode 87
- 9.2 Cordless flash mode 91
- Remote modes 91
- Remote groups 92
- Remote channels 92
- Reflector position for remote 93
- 9.2.2 SERVO mode 94
- 10 Flash techniques 98
- 11 Flash synchronisation 99
- 14 Care and maintenance 100
- 15 Troubleshooting 101
- 16 Technical data 103
- 17 Optional accessories 104
- Disposal of batteries 104
- Premessa 107
- 1 Per la vostra sicurezza 107
- 3 Preparazione del flash 108
- 2 Funzioni flash dedicate 108
- 4 Indicazioni sul flash 110
- 5 Indicazioni sul display 110
- 7 Modalità flash („Mode“) 112
- 7.2 Modo flash manuale 113
- 9.2 Controllo a distanza 117
- Modalità controllo a distanza 117
- Gruppi controllo a distanza 118
- Canali controllo a distanza 118
- 9.2.2 Modo SERVO 120
- 10 Tecniche lampo 124
- 11 Sincronizzazione del lampo 125
- 14 Cura e manutenzione 126
- 16 Dati tecnici 129
- 17 Accessori opzionali 130
- Smaltimento delle batterie 130
- Introducción 133
- 1 Indicaciones de seguridad 133
- 3 Preparación del flash 134
- 4 Indicadores LED en el flash 136
- 5 Indicaciones en la pantalla 136
- 5.2 Indicación del alcance 137
- 7.1 Modos TTL 138
- 7.2 Modo de flash manual 139
- 9.2 El funcionamiento Remoto 143
- Grupos remotos 144
- Canales remotos 144
- Comprobación del modo remoto 145
- 9.4 Desconexión automática 147
- 10 Técnicas de destello 150
- 11 Sincronización del flash 151
- 14 Mantenimiento y cuidados 152
- 15 Ayuda en caso de problemas 153
- 16 Características técnicas 155
- 17 Accesorios especiales 156
- Eliminación de las baterías 156
- 50 AF-1 O 164
- Metz - always first class 166
Related products and manuals for Flashlights Metz MECABLITZ 50 AF-1 digital Olympus
Flashlights Metz MECABLITZ 36 C-2 User Manual
(132 pages)
(132 pages)
Flashlights Metz MECABLITZ 36 AF-3 User Manual
(144 pages)
(144 pages)
© 2020, manymanuals.com. All rights reserved. | 1.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals