Metz 44 AF-1 digital Instruction Manual download pdf (Page 96)

96

ķ

8 Remote slave flash mode

In slave mode, the flash unit supports the

wireless Nikon remote system and is also

compatible with the Nikon “Advanced

Wireless Lighting” system.

This means that one or more slave flash

units can be controlled remotely from a

master or controller flash unit on the

camera (e.g. mecablitz 58 AF-1N digi-

tal) or from the camera master.

Slave flash unit 44AF-1 is always set to

slave Group A and all remote channels

1, 2, 3 and 4.

The slave flash units must be able to

receive light from the master or controller

flash unit via the integrated sensor  for

remote use.

The flash unit in the camera can func-

tion as a master or controller flash unit

depending on camera type. Further

information regarding settings on the

master or controller flash unit can be

found in the respective operating

instructions.

Configuration procedure for remote slave

flash mode

• Switch on the flash unit by pressing the

button .

• Press the “SL”  button on the flash

unit to configure the remote slave SL

flash mode.

The setting is effective immediately and

saved automatically.

Checking the remote flash mode

• Position the slave flash unit according

to subsequent shooting requirements.

A flash unit stand S60 (accessories)

should be used when setting up the

slave flash unit.

• Wait until all involved flash units are

ready. When flash readiness is achie-

ved for the slave units, the AF measu-

ring beam  will start flashing.

• To release a test flash, press the manu-

al firing button  on the master or

controller flash unit. The slave flash

units will respond with a test flash.

Should a slave not respond, adjust the

position of the slave so that the slave

sensor  can receive light from the

master or controller flash unit.

Ǽ

M

TTL

SL

Ǽ

M

TTL

SL

☞

Ǽ

Ǽ

M

TTL

SL

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 173 174

Comments to this Manuals

No comments