Metz 44 AF-1 digital Instruction Manual download pdf (Page 84)

84

ķ

3 Preparing the flash unit for

use

3.1 Mounting the flash unit

Mounting the flash unit on the camera

Turn off the camera and flash before

mounting or removing.

• Turn the knurled nut  towards the

flash unit housing as far as it will go.

The locking pin in the adapter shoe is

now fully retracted into the case.

• Slide the flash unit foot completely into

the camera accessory shoe.

• Turn the knurled nut  towards the

camera housing as far as it will go,

clamping the flash unit in place. If the

camera does not have a locking hole,

the spring-loaded locking pin retracts

into the adapter case so as not to

damage the surface.

Removing the flash unit from the camera

Turn off the camera and flash before

mounting or dismounting.

• Turn the knurled nut  towards the

flash unit housing as far as it will go.

• Remove the flash unit from the

camera’s accessory shoe.

3.2 Power supply

Suitable batteries/rechargeable batteries

The flash unit can be operated with any

of the following batteries:

• 4 NiCad batteries 1.2V, type IEC KR6

(size AA).

They permit very fast recycling times

and are eco-nomical in use because

they are rechargeable.

• 4 nickel-metal-hydride batteries 1.2V,

type IEC HR6 (size AA). They have a

significantly higher capacity than

NiCad batteries and are less harmful

to the environment, since they have no

cadmium.

• 4 alkaline-manganese dry cell batte-

ries 1.5V, type IEC LR6 (size AA).

Maintenance-free power source for

moderate power requirements.

☞

☞

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 165 166

Comments to this Manuals

No comments